Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1994CHEROKEE COUNTRY, 4D UTILITY, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSKEYLESS ENTRY SYSTEMREMOVAL & INSTALLATIONKEYLESS ENTRY MODULE (WITHOUT OVERHEAD CONSOLE)
1994 Jeep Cherokee Country, 4D Utility, RWD
Keyless Entry Module (Without Overhead Console)
1994 Jeep Cherokee Country, 4D Utility, RWDSECTION Keyless Entry Module (Without Overhead Console)
- Remove screws attaching receiver housing to headlining. See Fig 1 .
- Pull housing toward rear of vehicle to disengage clip.
- Disconnect receiver harness connector.
- Remove circuit board from housing.
- To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.