Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1994CHEROKEE COUNTRY, 2D UTILITY, RWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONWHEEL ALIGNMENTWHEEL ALIGNMENT SPECIFICATIONS & PROCEDURESALIGNMENT SPECIFICATIONS
1994 Jeep Cherokee Country, 2D Utility, RWD, Standard
Alignment Specifications
1994 Jeep Cherokee Country, 2D Utility, RWD, StandardSECTION Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Preferred | Range | ||||||
|---|---|---|---|---|---|---|---|---|
| Cherokee | ||||||||
| Camber (1) | 0 | -.75 to .50 | ||||||
| Caster (1) | 6 | 5 to 7 | ||||||
| Toe-In (1) | 0 | -.06 to .06 | ||||||
| Toe-In (2) | 0 | -.03 to .03 | ||||||
| Toe-Out On Turns (1) | 32.5 | 32.5 | ||||||
| Grand Cherokee | ||||||||
| Camber (1) | -0.25 | -.75 to .50 | ||||||
| Caster (1) | 7 | 6.5 to 7.5 | ||||||
| Toe-In (1) | .24 | .24 to .44 | ||||||
| Toe-In (2) | .12 | .12 to .22 | ||||||
| Toe-Out On Turns (1) | 33 | 33 | ||||||
| Wrangler | ||||||||
| Camber (1) | 0 | -0.5 to 0.5 | ||||||
| Caster (1) | ||||||||
| Manual Transmission | 8 | 6.5 to 9.0 | ||||||
| Automatic Transmission | 6.5 | 5.25 to 7.25 | ||||||
| Toe-In (1) | 0 | -.1 to .1 | ||||||
| Toe-In (2) | 0 | -.05 to .05 | ||||||
| Toe-Out On Turns (1) | 32.5 | 32.5 | ||||||
|
||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.