Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1994CHEROKEE COUNTRY, 2D UTILITY, RWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODES - BODY CONTROL COMPUTERSELF-DIAGNOSTIC TESTSTEST 38A - IDENTIFYING CHIME SYSTEM PROBLEM
1994 Jeep Cherokee Country, 2D Utility, RWD, Standard
Test 38A - Identifying Chime System Problem
1994 Jeep Cherokee Country, 2D Utility, RWD, StandardSECTION Test 38A - Identifying Chime System Problem
Chime system diagnostics is separated into 3 categories. Verify customer complaint and identify problem area before performing appropriate test. See DIAGNOSING CHIME SYSTEM table.
DIAGNOSING CHIME SYSTEM
| Description | Perform TEST | |
|---|---|---|
| Chime Does Not Operate At All | TEST 38B | |
| Chimes All The Time | ||
| With Driver's Seat Belt Fastened | TEST 38C | |
| With Driver's Door Open & Key Removed From Ignition | TEST 38D | |
| Does Not Chime | ||
| Exterior Lamps On, Ign. Key Removed & Driver Door Open | TEST 39A | |
| Ignition Off, Key In Ignition & Driver's Door Open | TEST 39B | |
| Seat Belt Fastened & Ignition In RUN Position | TEST 39C | |
| Either Signal Left On For One Mile At More Than 15 MPH | TEST 39D | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.