Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1991CHEROKEE 2WD L4-150 2.5L VIN P MFIREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSSPECIFICATIONSMECHANICAL SPECIFICATIONS
1991 Jeep Cherokee 2WD L4-150 2.5L VIN P MFI
Mechanical Specifications
1991 Jeep Cherokee 2WD L4-150 2.5L VIN P MFISECTION Mechanical Specifications
Master cylinder/modulator bracket nut torque 36 Nm (27 ft. lbs.)
Inner mounting bracket nuts torque 42 Nm (31 ft. lbs.)
Push rod bolt inner lock nut torque 34 Nm (25 ft. lbs.)
Outer jam nut torque 8.5 Nm. (75 in. lbs)
Sensor bolt torque 14 Nm (11 ft. lbs.)
Front sensor air gap 0.33 - 0.48 mm (0.013 - 0.019 inch)
Rear sensor air gap 0.76 - 0.91 mm (0.030 - 0.036 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.