Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1989WRANGLER BASE, 4.2 T, STANDARD, BA10/5REPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONMANUAL TRANSOVERHAUL - BA 10/5 5-SPEEDCOMPONENT DISASSEMBLY & REASSEMBLYCLUTCH HOUSINGREASSEMBLY
1989 Jeep Wrangler Base, 4.2 T, Standard, BA10/5
Clutch Housing: Reassembly
1989 Jeep Wrangler Base, 4.2 T, Standard, BA10/5SECTION Reassembly
Lubricate release bearing guide bore and press into clutch housing with hole facing towards pressure relief slots of clutch housing. See Fig 1. Install oil seal (if equipped). Install snap ring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.