Engine Mechanical: Mechanical: Crankshaft: Remove & Replace

1987 Jeep Cherokee Pioneer, 2D Utility, 4.0 M, 4WD, AutomaticSECTION Remove & Replace
WARNING: This page is about the Cherokee Base, 2D Utility, 2.1 B, which is a different variant/trim than selected.
Includes: R&I Engine, replace Rod Bearings, Main Bearings, Front Crankshaft Seal and Rear Main Seal. Clean Oil Pan, Baffle Plate, and Oil Strainer.

Applies ToNoteStandard HoursWarranty HoursSkill Level
In-Line4,Diesel11.7A
Additional Procedure: CRANKSHAFT: Remove & Replace:
4WD, w/Std Trans add1.5A
w/Frame Tie Bar add0.2A
Where Air Cond interferes add0.6A
Where Air Pump interferes add0.2A
Where Skid Plate interferes add0.4A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.