Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Upper Control Arm & Axle Housing Pivot Bushing: Installation
1987 Jeep Cherokee LimitedSECTION Installation
- To install new upper control arm bushing into bracket bore on axle housing, first position bushing on Remover/Installer (J-35581-2 ) and Nut (J-21474-18 ). Position tools and bushing in control arm bracket, then assemble remaining installer tools. See Fig 1.
- Turn nut to press bushing into housing until fully seated in bore. See Fig 1. Detach remover/installer tools (and spacer), then connect upper control arm at frame and axle housing brackets. Tighten mounting bolts. To complete installation, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.