Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1987CHEROKEE LIMITEDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEM2.5L TBI SYSTEMOPERATIONMODES OF OPERATIONIGNITION SWITCH "OFF" MODE
1987 Jeep Cherokee Limited
Ignition Switch "Off" Mode
1987 Jeep Cherokee LimitedSECTION Ignition Switch "Off" Mode
When ignition switch is turned "OFF", the ECU ceases to provide ground for the injector and all fuel injection stops. The ECU causes the idle speed actuator to fully extend for the next start up. The ECU then deactivates.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.