Removal & Installation

1986 Jeep Wagoneer Limited, 2.1 BSECTION Removal & Installation
WARNING: This page is about the Wagoneer Base, 2.1 B, which is a different variant/trim than selected.
Applies ToNoteStandard HoursWarranty HoursSkill Level
exc Selec-Trac2.01.4C
Selec-Trac2.31.7C
Additional Procedure: TRANSFER CASE ASSEMBLY: Removal & Installation:
Where Skid Plate interferes add0.2C
Combination Procedure: FRONT DRIVE CHAIN: Replace:
1.1A
Combination Procedure: HOUSING ASSEMBLY: Remove & Replace:
Front3.0A
Rear1.0A
Combination Procedure: TRANSFER CASE ASSEMBLY: Replace:
0.3C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.