Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1986CHEROKEE CHIEF, 4D UTILITY, 2.8 W, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEIGNITION SYSTEMIGNITION SYSTEM - SOLID STATETESTINGCONTROL UNIT POWER FEED CHECK
1986 Jeep Cherokee Chief, 4D Utility, 2.8 W, Automatic
Control Unit Power Feed Check
1986 Jeep Cherokee Chief, 4D Utility, 2.8 W, AutomaticSECTION Control Unit Power Feed Check
NOTE:
Always check ignition coil primary circuit first before making this check.
- Disconnect 2-wire connector at control unit. Connect voltmeter negative lead to ground and positive lead to harness connector terminal "F2". If reading is the same as battery voltage, with ignition on, replace control unit. If not, proceed to next step.
- Connect voltmeter negative lead to ground and positive lead to Light Blue wire at harness connector terminal "F1" in 2-wire connector. Crank engine. Voltmeter reading should be within one volt of battery cranking voltage. If not, check for bad connections, ignition switch or starter solenoid.
- Turn ignition switch off. Connect 2-wire connector and disconnect 4-wire connector. Attach ammeter between ground and Black wire terminal "C1" on control unit side of connector. With ignition on, reading should be 0.9-1.1 amps. If reading is other than specified, replace control unit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.