Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1986CHEROKEE BASE, 2D UTILITY, 2.8 W, RWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (SERVICING - A/T)ADJUSTMENTSTRANSMISSION THROTTLE ROD
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, Automatic
Transmission Throttle Rod
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, AutomaticSECTION Transmission Throttle Rod
WARNING: This page is about a different car, the 1984 Plymouth Gran Fury, 1984 Dodge Diplomat, and 1984 Chrysler Fifth Avenue. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure carburetor is not on fast idle cam (disconnect choke if necessary). Raise vehicle on hoist to make adjustment at transmission throttle lever. Loosen adjustment swivel lock screw.NOTE: Swivel must be free to slide along flat end of throttle rod so that preload spring action is not restricted.
- Hold transmission lever firmly forward against its internal stop and tighten swivel lock screw. This completes throttle rod adjustment, as linkage backlash was automatically removed by the preload spring.
- To check linkage freedom of operation, move throttle rod rearward, and release slowly. Ensure it returns to full forward position.
Swivel must be free to slide on throttle rod for proper adjustment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.