Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP1986CHEROKEE BASE, 2D UTILITY, 2.8 W, RWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3 (WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES)ADJUSTMENTSCASTER ADJUSTMENT

1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, Automatic

Caster Adjustment

1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, AutomaticSECTION Caster Adjustment

WARNING: This page is about a different car, the 1986 Jeep Pickup and 1986 Jeep Grand Wagoneer. However, it is still accessible from the selected car via links, so may be relevant.

Caster adjustment is made by inserting shims between spring and axle. To increase caster, insert thick portion of shim toward rear of vehicle. To decrease caster, insert thick portion of shim toward front of vehicle.

Fig 1: Caster Adjustment To adjust, insert shim between spring and axle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.