Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1986CHEROKEE BASE, 2D UTILITY, 2.8 W, RWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 19 (SERVICING - A/T)ADJUSTMENTSNEUTRAL SAFETY SWITCH ADJUSTMENTSNOTES
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, Automatic
Neutral Safety Switch Adjustments: Notes
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, AutomaticSECTION Notes
WARNING: This page is about a different car, the 1990 Dodge Ram Wagon, 1990 Dodge Ram Van, 1990 Dodge Pickup, 1990 Dodge Dakota, and 1990 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
A combination neutral safety and back-up light switch is screwed into side of transaxle case. Switch is not adjustable. Switch may be tested for continuity using the following method.
NOTE:
Ensure gearshift linkage is properly adjusted before replacing a switch that tests bad.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.