Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1986CHEROKEE BASE, 2D UTILITY, 2.8 W, RWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (SERVICING - A/T)ADJUSTMENTKICKDOWN (FRONT) BAND
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, Automatic
KICKDOWN (Front) Band
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, AutomaticSECTION KICKDOWN (Front) Band
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1988 Dodge Ramcharger, 1988 Dodge Ram Wagon, 1988 Dodge Ram Van, 1988 Dodge Pickup, and 1988 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Locate kickdown band adjusting screw at left side of transmission case, near throttle lever shaft. Loosen adjusting screw lock nut and back off 5 turns. Ensure adjusting screw turns freely in case.
- Using Wrench (C-3380-A) with Adapter (C-3705), tighten adjusting screw to 48 INCH lbs. (5 N.m). If adapter is not used, tighten adjusting screw to 72 INCH lbs. (8 N.m).
- Back off front adjusting screw. See KICKDOWN BAND ADJUSTMENT
. Hold adjusting screw in position and tighten lock nut to 35 ft. lbs. (47 N.m).KICKDOWN BAND ADJUSTMENT
Application Back Off Screw All Models 2 1/2 Turns
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.