Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1986CHEROKEE BASE, 2D UTILITY, 2.8 W, RWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (SERVICING - A/T)ADJUSTMENTSHIFT LINKAGEFLOOR SHIFT (FWD MODELS)
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, Automatic
Floor Shift (FWD Models)
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, AutomaticSECTION Floor Shift (FWD Models)
WARNING: This page is about a different car, the 1985 Dodge Ramcharger, 1985 Dodge Ram Wagon, 1985 Dodge Ram Van, 1985 Dodge Pickup, and 1985 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Place shift selector in "PARK" position. Loosen lock bolt on cable adjusting bracket on transaxle. Move shift lever on transaxle all the way to rear detent (park position) and hold. Tighten lock bolt.
NOTE:
If it is necessary to disassemble linkage cable from lever, replace old plastic grommets with new ones. Use pliers to snap new grommet into lever and rod into grommet.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.