Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1986CHEROKEE BASE, 2D UTILITY, 2.8 W, RWD, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (SERVICING - A/T)ADJUSTMENTLOW-REVERSE BAND (REAR)REAR WHEEL DRIVE MODELS
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, Automatic
Rear Wheel Drive Models
1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, AutomaticSECTION Rear Wheel Drive Models
WARNING: This page is about a different car, the 1985 Dodge Ramcharger, 1985 Dodge Ram Wagon, 1985 Dodge Ram Van, 1985 Dodge Pickup, and 1985 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Drain transmission and remove oil pan. Locate low-reverse band adjusting screw on rear servo lever.
- Loosen adjusting screw lock nut approximately 5 turns and make sure screw turns freely in lever. Using special wrench (C3380-A), tighten adjusting screw to 72 INCH lbs. (8.1 N.m).
- Back off adjusting screw specified number of turns as given in Low-Reverse Band Adjustment table. Hold adjusting screw in position and tighten lock nut to 30 ft. lbs. (41 N.m). Clean oil pan. Install new gasket with pan and fill transmission with fluid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.