Reverse Delay Valve

1986 Jeep Cherokee Base, 2D Utility, 2.8 W, RWD, AutomaticSECTION Reverse Delay Valve
  1. Connect external vacuum source to port on White side of delay valve. Connect 1 end of a section of rubber hose to vacuum gauge and other end to port on colored (non-White) side of valve.
  2. With elapsed time device in view and a constant 10 in. Hg vacuum applied, note time required for gauge pointer to move from 0-8 in. Hg.
  3. If valve fails to meet time limits, replace valve. If valve meets specifications, install with non-White side toward vacuum source.
REVERSE DELAY VALVE TIME LIMITS (1)

Valve Color Min. Time Max. Time
White/Purple 3.2 4.8
White/Gray 8 12
White/Gold 12 18
White/Brown 16 24
White/Yellow 80 120
White/Red 300 450
White/Orange 1.5 2.5
(1) Time in seconds.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.