Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJAGUAR2018XE BASE, 2.0L ENG VIN N, AWDREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE SYSTEM - GENERAL INFORMATION -- XE (X760)ENGINE SYSTEM - GENERAL INFORMATIONCONNECTING ROD LARGE END BOREGENERAL PROCEDURES

2018 Jaguar XE Base, 2.0L Eng VIN N, AWD

General Procedures

2018 Jaguar XE Base, 2.0L Eng VIN N, AWDSECTION General Procedures

Measure the bearing bore in two directions. The difference is the connecting rod bore out-of-round. Verify the out-of-round is within specification.
Measure the bearing bore diameter in two directions. Verify the bearing bore is within specification.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.