Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Jaguar F-Pace BaseFACTORY OEM SERVICE PROCEDURE
DTC U2001-98: Reduced System Function - Component Or System Over Temperature: Action
NOTE:
The system is designed to give a heavier but stable steering feel when high temperature is detected to protect the system from permanent damage. It is recommended to reduce level of steering inputs to the steering in the specific scenarios identified by the customer to provoke the problem. Depending on the level of reduction this could be accompanied by an alert
- Check for heat shield damage or mud packing around power steering control module. Allow the power steering control module to cool. Consider the environmental temperature. Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the DTCs and retest
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.