Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Jaguar F-Pace BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Index DTC: Power Steering Control Module (PSCM) - F-Pace
- Diagnostic Trouble Code Index DTC: Power Steering Control Module (PSCM)
- Description And Operation
- Power Steering Control Module (PSCM)
- Notes
- DTC B1304-04: Electronic Power Assisted Steering System - System Internal Failures
- DTC B1304-07: Electronic Power Assisted Steering System - Mechanical failures
- DTC B1304-16: Electronic Power Assisted Steering System - Circuit voltage below threshold
- DTC B1304-17: Electronic Power Assisted Steering System - Circuit voltage above threshold
- DTC B1304-1C: Electronic Power Assisted Steering System - Circuit voltage out of range
- DTC B1304-98: Electronic Power Assisted Steering System - Component or system over temperature
- DTC C102D-07: High Friction Inside Power Steering - Mechanical failures
- DTC C200B-01: Steering Shaft Torque Sensor 1 - General electrical failure
- DTC C200B-31: Steering Shaft Torque Sensor 1 - No signal
- DTC C1B00-62: Steering Angle Sensor - Signal Compare Failure
- DTC U0001-81: High Speed CAN Communication Bus - Invalid serial data received
- DTC U0001-82: High Speed CAN Communication Bus - Alive/sequence counter incorrect/not updated
- DTC U0001-87: High Speed CAN Communication Bus - Missing message
- DTC U0001-88: High Speed CAN Communication Bus - Bus off
- DTC U0300-56: Internal Control Module Software Incompatibility - Invalid/incomplete configuration
- DTC U1A4C-53: Build/End of Line Mode Active - Deactivated
- DTC U2001-00: Reduced System Function - No Sub Type Information
- DTC U2001-07: Reduced System Function - Mechanical Failures
- DTC U2001-16: Reduced System Function - Circuit Voltage Below Threshold
- DTC U2001-17: Reduced System Function - Circuit Voltage Above Threshold
- DTC U2001-98: Reduced System Function - Component Or System Over Temperature
- DTC U2100-56: Initial Configuration Not Complete - Invalid/incomplete configuration
- DTC U2300-54: Central Configuration - Missing calibration
- DTC U2300-55: Central Configuration - Not configured
- DTC U2300-56: Central Configuration - Invalid/incomplete configuration
- DTC U3001-00: Control Module Improper Shutdown - No sub type information
- Power Steering Control Module (PSCM)
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.