Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2016XJR BASEREPAIR AND DIAGNOSISGENERAL INFORMATIONDTC INDEXDIAGNOSTIC TROUBLE CODE INDEX DTC: STEERING ANGLE SENSOR MODULE (SASM) -- XJ/X351
2016 Jaguar XJR Base
Diagnostic Trouble Code Index DTC: Steering Angle Sensor Module (SASM) -- XJ/X351
2016 Jaguar XJR BaseSECTION Diagnostic Trouble Code Index DTC: Steering Angle Sensor Module (SASM) -- XJ/X351
- Diagnostic Trouble Codes (DTCS) Index DTC: Steering Angle Sensor Module (SASM)
- Description And Operation
- Steering Angle Sensor Module (SASM)
- Notes
- DTC C1B00-1C: Steering Angle Sensor - Circuit voltage out of range
- DTC C1B00-49: Steering Angle Sensor - Internal electronic failure
- DTC C1B00-61: Steering Angle Sensor - Signal calculation failure
- DTC C1B00-62: Steering Angle Sensor - Signal compare failure
- DTC C1B00-64: Steering Angle Sensor - Signal plausibility failure
- DTC C1B00-81: Steering Angle Sensor - Invalid serial data received
- DTC C1B00-85: Steering Angle Sensor - Signal above allowable range
- DTC C1B00-92: Steering Angle Sensor - Performance or incorrect operation
- DTC C1B00-96: Steering Angle Sensor - Component internal failure
- DTC C1B00-97: Steering Angle Sensor - Component or system operation obstructed or blocked
- DTC U0001-88: High Speed CAN Communication Bus - Bus off
- DTC U0300-00: Internal Control Module Software Incompatibility - No sub type information
- DTC U3003-62: Battery Voltage - Signal compare failure
- Steering Angle Sensor Module (SASM)
- Description And Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.