Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Stall Detection
A seat adjustment motor is deemed to have stalled if there is no change in the input from the feedback sensor of the motor for 200 ms. If a stall condition is detected then the drive to that motor is cancelled for the remainder of the memory recall operation or until the switch is re-selected (manual movement). The motor may be activated again, to move past the stall position, by pressing the appropriate switch for more than 2 seconds. If sensor feedback is detected, then the motor will continue to be driven until the switch is released. If sensor feedback is not detected, then the motor is only driven for 0.5 second and then stops until the switch is released and pressed again, when a further 0.5 second of activation is permitted. This is known as inch mode, which allows seat adjustment to be maintained if sensor feedback is lost.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.