Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2011XJ SUPERCHARGEDREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXDIAGNOSTIC TROUBLE CODE (DTC) INDEX DTC: POWER STEERING CONTROL MODULE (PSCM) -- XJ/X351
2011 Jaguar XJ Supercharged
Diagnostic Trouble Code (DTC) Index DTC: Power Steering Control Module (PSCM) -- XJ/X351
2011 Jaguar XJ SuperchargedSECTION Diagnostic Trouble Code (DTC) Index DTC: Power Steering Control Module (PSCM) -- XJ/X351
- DIAGNOSTIC TROUBLE CODE (DTC) INDEX DTC: Power Steering Control Module (PSCM)
- Description And Operation
- Power Steering Control Module (PSCM)
- Notes
- B1304-04 Electronic Power Assisted Steering System - System Internal Failures
- B1304-07 Electronic Power Assisted Steering System - Mechanical failures
- B1304-16 Electronic Power Assisted Steering System - Circuit voltage below threshold
- B1304-17 Electronic Power Assisted Steering System - Circuit voltage above threshold
- B1304-1C Electronic Power Assisted Steering System - Circuit voltage out of range
- B1304-98 Electronic Power Assisted Steering System - Component or system over temperature
- C102D-07 High Friction Inside Power Steering - Mechanical failures
- C1B00-62 Steering Angle Sensor - Signal compare failure
- C200B-01 Steering Shaft Torque Sensor 1 - General electrical failure
- C200B-31 Steering Shaft Torque Sensor 1 - No signal
- U0001-81 High Speed CAN Communication Bus - Invalid serial data received
- U0001-82 High Speed CAN Communication Bus - Alive/sequence counter incorrect/not updated
- U0001-87 High Speed CAN Communication Bus - Missing message
- U0001-88 High Speed CAN Communication Bus - Bus off
- U0300-56 Internal Control Module Software Incompatibility - Invalid/incomplete configuration
- U1A4C-53 Build / End of Line Mode Active - Deactivated
- U2001-00 Reduced System Function - No sub type information
- U2001-07 Reduced System Function - Mechanical failures
- U2001-16 Reduced System Function - Circuit voltage below threshold
- U2001-17 Reduced System Function - Circuit voltage above threshold
- U2001-98 Reduced System Function - Component or system over temperature
- U2100-56 Initial Configuration Not Complete - Invalid/incomplete configuration
- U2300-54 Central Configuration - Missing calibration
- U2300-55 Central Configuration - Not configured
- U2300-56 Central Configuration - Invalid/Incomplete configuration
- U3001-00 Control Module Improper Shutdown - No sub type information
- Power Steering Control Module (PSCM)
- Description And Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.