Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2011XJ SUPERCHARGEDREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXDIAGNOSTIC TROUBLE CODE (DTC) INDEX DTC: LUGGAGE COMPARTMENT MODULE (LCLCM) -- XJ/X351
2011 Jaguar XJ Supercharged
Diagnostic Trouble Code (DTC) Index DTC: Luggage Compartment Module (LCLCM) -- XJ/X351
2011 Jaguar XJ SuperchargedSECTION Diagnostic Trouble Code (DTC) Index DTC: Luggage Compartment Module (LCLCM) -- XJ/X351
- DIAGNOSTIC TROUBLE CODE (DTC) INDEX DTC: Luggage Compartment Module (LCLCM)
- Description And Operation
- Luggage Compartment Lid Control Module (LCLCM)
- Notes
- DTC B10D0-23: Trunk Latch Clutch Switch - Signal stuck low
- DTC B11C4-23: Boot/Trunk Close Button - Signal stuck low
- DTC B1316-02: Boot/Trunk Latch Power Close Unit - General signal failure
- DTC B1316-93: Boot/Trunk Latch Power Close Unit - No operation
- DTC C2006-11: Left Actuator - Circuit short to ground
- DTC C2006-12: Left Actuator - Circuit short to battery
- DTC C2006-13: Left Actuator - Circuit open
- DTC C2006-15: Left Actuator - Circuit short to battery or open
- DTC C2006-19: Left Actuator - Circuit current above threshold
- DTC C2006-31: Left Actuator - No signal
- DTC U0001-88: High Speed CAN Communication Bus - Bus off
- DTC U0140-00: Lost Communication With Body Control Module - No sub type information
- DTC U0300-00: Internal Control Module Software Incompatibility - No sub type information
- DTC U0401-68: Invalid Data Received From ECM/PCM A - Event information
- DTC U0415-68: Invalid Data Received From Anti-Lock Brake System (ABS) Control Module - Event information
- DTC U201A-51: Control Module Main Calibration Data - Not programmed
- DTC U201A-52: Control Module Main Calibration Data - Not activated
- DTC U2100-00: Initial Configuration Not Complete - No sub type information
- DTC U2101-00: Control Module Configuration Incompatible - No sub type information
- DTC U3000-44: Control Module - Data memory failure
- DTC U3000-45: Control Module - Program memory failure
- DTC U3000-46: Control Module - Calibration/parameter memory failure
- DTC U3000-49: Control Module - Internal electronic failure
- DTC U3000-4B: Control Module - Over temperature
- DTC U3003-62: Battery Voltage - Signal compare failure
- Luggage Compartment Lid Control Module (LCLCM)
- Description And Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.