Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2008XK (X150) V8-4.2LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIR
2008 Jaguar XK (X150) V8-4.2L
Power Window Switch: Service and Repair
2008 Jaguar XK (X150) V8-4.2LSECTION Service and Repair
Window Control Switch (86.25.08)
Removal
1. Remove the grab handle cover.
- Release from the 6 clips.
2. Remove the window control switch.
- Release from the 3 clips.
- Disconnect the electrical connector.
Installation
1. Install the window control switch.
- Connect the electrical connector.
- Secure in the clips.
2. Install the grab handle cover.
- Secure in the clips.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.