Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2008XK (X150) V8-4.2LREPAIR AND DIAGNOSISBODY AND FRAMEBUMPERREAR BUMPERSERVICE AND REPAIR
2008 Jaguar XK (X150) V8-4.2L
Rear Bumper: Service and Repair
2008 Jaguar XK (X150) V8-4.2LSECTION Service and Repair
Rear Bumper (76.22.27)
Removal
CAUTION: Always protect paintwork and glass when removing exterior components.
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the rear bumper cover.
3. With assistance, remove the bumper.
- Remove the 4 bolts.
4. Remove the 2 crush tubes.
- Remove the 8 nuts.
Installation
1. Install the 2 crush tubes.
- Tighten the nuts to 25 Nm (18 lb.ft).
2. With assistance, install the bumper.
- Tighten the M8 bolts to 25 Nm (18 lb.ft).
3. Install the rear bumper cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.