Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2006XJ (X350) V8-4.2L SCREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD, ENGINE
2006 Jaguar XJ (X350) V8-4.2L SC
Connecting Rod, Engine
2006 Jaguar XJ (X350) V8-4.2L SCSECTION Connecting Rod, Engine
Connecting Rod Bolt
CAUTION: Bolts must be tightened equally.
NOTE: Remove the special tools from the connecting rods.
Position the connecting rod cap on the appropriate connecting rod.
Tighten to 10 Nm.
Tighten to 30 Nm.
Tighten to 90°.Connecting Rod Cap
Tighten 10 Nm
Tighten 30 Nm
Tighten 90°
CAUTION: Bolts must be tightened equally.
NOTE: Remove the special tools from the connecting rods.
Position the connecting rod cap on the appropriate connecting rod.
Tighten to 10 Nm.
Tighten to 30 Nm.
Tighten to 90°.Connecting Rod Cap
Tighten 10 Nm
Tighten 30 Nm
Tighten 90°
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.