Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2006XJ (X350) V8-4.2L SCREPAIR AND DIAGNOSISMAINTENANCEWHEELS AND TIRESSERVICE AND REPAIRPROCEDURESWHEEL AND TIRE
2006 Jaguar XJ (X350) V8-4.2L SC
Wheel and Tire
2006 Jaguar XJ (X350) V8-4.2L SCSECTION Wheel and Tire
Wheel and Tire (74.20.05)
Removal
1. CAUTION: Do not use heat to loosen a seized wheel nut. Excessive heat may cause damage to the wheel and wheel bearings.
Loosen the wheel nuts.
2. Raise and support the vehicle.
3. Remove the wheel and tire assembly.
Installation
1. WARNING: Make sure there is no contamination of the wheel, hub or brake disc contact surfaces. Installation without metal to metal contact at the mounting surfaces may cause the wheel nuts to loosen and allow the wheel to detach with the vehicle in motion. Failure to follow these instructions may result in personal injury.
WARNING: Apply a small amount of grease to the hub and wheel mating surfaces before installation. Make sure the grease does not come into contact with the vehicles braking components and the wheel stud threads. Failure to follow these instructions may result in personal injury.
To install, reverse the removal procedure.
^ Tighten to 125 Nm.
Removal
1. CAUTION: Do not use heat to loosen a seized wheel nut. Excessive heat may cause damage to the wheel and wheel bearings.
Loosen the wheel nuts.
2. Raise and support the vehicle.
3. Remove the wheel and tire assembly.
Installation
1. WARNING: Make sure there is no contamination of the wheel, hub or brake disc contact surfaces. Installation without metal to metal contact at the mounting surfaces may cause the wheel nuts to loosen and allow the wheel to detach with the vehicle in motion. Failure to follow these instructions may result in personal injury.
WARNING: Apply a small amount of grease to the hub and wheel mating surfaces before installation. Make sure the grease does not come into contact with the vehicles braking components and the wheel stud threads. Failure to follow these instructions may result in personal injury.
To install, reverse the removal procedure.
^ Tighten to 125 Nm.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.