Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2005XJ8 BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESMODULE COMMUNICATIONS NETWORK (2003.5-09)DIAGNOSIS AND TESTINGPINPOINT TESTSPINPOINT TEST G239843P4: CHECK THE ISO NETWORK CIRCUITG239843T42: CHECK THE ISO CIRCUIT FOR SHORT TO GROUND
2005 Jaguar XJ8 Base
G239843t42: CHECK THE ISO CIRCUIT FOR SHORT TO GROUND
2005 Jaguar XJ8 BaseSECTION G239843t42: CHECK THE ISO CIRCUIT FOR SHORT TO GROUND
- Measure the resistance between pin 07 of the DLC (W) and GROUND.
- Is the resistance less than 10,000 ohms?
- -> Yes: REPAIR the short circuit. For additional information, refer to the wiring diagrams. Test the system for normal operation.
- -> No: GO to Pinpoint Test G239843t43: CHECK THE ISO CIRCUIT BETWEEN THE RIGHT-HAND HID AND THE DLC FOR HIGH RESISTANCE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.