Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connector Pins Identification
2003 Jaguar XK8 2D CoupeSECTION Connector Pins Identification
| Pin Number | Circuit | Circuit Function |
|---|---|---|
| 001 | Compressor ON signal | |
| 002 | Coolant valve | |
| 003 | RH Blower motor relay | |
| 004 | Heated windshield relays (where fitted) | |
| 005 | Heated door mirror relay | |
| 006 | Defrost servomotor (positive) | |
| 007 | Center vent servomotor (positive) | |
| 008 | LH air intake servomotor fresh / recirculation (positive) | |
| 009 | RH air intake servomotor fresh / recirculation (positive) | |
| 010 | Not used | |
| 011 | Not used | |
| 012 | Foot servomotor (positive) | |
| 013 | Cool air bypass servomotor (positive) | |
| 014 | Not used | |
| 015 | Not used | |
| 016 | LH Blower motor relay | |
| 017 | Coolant pump motor relay | |
| 018 | Heated backlight relay | |
| 019 | Defrost servomotor (negative) | |
| 020 | Center vent servomotor (negative) | |
| 021 | LH air intake servomotor fresh / recirculation (negative) | |
| 022 | RH air intake servomotor fresh / recirculation (negative) | |
| 023 | Not used | |
| 024 | Not used | |
| 025 | Foot servomotor (negative) | |
| 026 | Cool air bypass servomotor (negative) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.