Using Toyota Hand-Held Tester

2002 Jaguar XKR 100, 2D CoupeSECTION Using Toyota Hand-Held Tester
  1. Connect hand-held tester to data link connector No. 3. When using hand-held tester, more detailed procedures may be displayed on tester while performing this procedure.
  2. Insert registered master key in ignition lock cylinder. Turn ignition on. Request KEY CODE DELETION from hand-held tester. Ensure SECURITY indicator light flashes. SECURITY indicator light is displayed as a vehicle icon near the center of the tachometer.
  3. Within 10 seconds of requesting KEY CODE DELETION on hand-held tester, remove master key from ignition lock cylinder. Procedure is now complete and transponder key code should now be erased. If master key cannot be removed from ignition lock cylinder, transponder key code erasure is cancelled and SECURITY indicator light will turn off.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.