Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2002XKR 100, 2D COUPEREPAIR AND DIAGNOSISGENERAL INFORMATIONCOMPUTER RELEARN PROCEDURES - IMPORTLEXUSERASURE OF TRANSPONDER KEY CODEUSING IGNITION SWITCH
2002 Jaguar XKR 100, 2D Coupe
Using Ignition Switch
2002 Jaguar XKR 100, 2D CoupeSECTION Using Ignition Switch
NOTE:
Ensure driver's door is closed and ignition key is not inserted in ignition switch.
- Insert master key in ignition.
- Perform this step within 35 seconds. Turn ignition switch on/off 6 times. Open/close driver's door 7 times. Security indicator will be off.
- Perform this step within 10 seconds. Remove master key. Security indicator should flash for one second, then go off. Procedure is now completed. Key code should now be erased. If key cannot be removed from ignition, key code deletion is canceled. Security indicator will turn off. Repeat procedure from step 1.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.