Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2002XK8 2D COUPEREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS, FRAMES AND MECHANISMSGENERAL PROCEDURESDOOR WINDOW GLASS ADJUSTMENT
2002 Jaguar XK8 2D Coupe
Door Window Glass Adjustment
2002 Jaguar XK8 2D CoupeSECTION Door Window Glass Adjustment
- Turn ignition key to position II and motor door glass to fully lowered position.
- Turn ignition key to position O
- Remove door switchpack and door casing and disconnect switchpack harness multiplug. Refer to DOOR TRIM PANEL .
- Remove door water shedders. Refer to EXTERIOR DRIVER DOOR HANDLE and/or EXTERIOR PASSENGER DOOR HANDLE .
- Reconnect door glass lift switch lead to glass regulator connector.
- Remove door outer waist moulding. Refer to DOOR WINDOW MOULDING .
- Using a felt tip pen mark datum lines on glass.
- Draw a horizontal line across glass 6mm from the top edge on coupe or 9mm down on convertible.
- Draw a parallel line 6mm from glass leading edge.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.