Specifications Index

2002 Jaguar XK8 2D CoupeSECTION Specifications Index
XK SERIES SPECIFICATIONS INDEX

System Specification/Procedure
Air Conditioning
Service Specification
Torque INSTALLATION
Axle Nut/Hub Nut
Front 270-330 Nm
Rear 304-336 Nm
Battery N/A
Brakes
Bleeding Sequence BLEEDING PROCEDURE
Disc Brakes
Service Specifications DISC BRAKE SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Charging
Generator GENERATOR
Torque TORQUE SPECIFICATIONS
Drive Belts
Adjustment BELT ADJUSTMENT
Belt Routing DRIVE BELT ROUTING
Engine Cooling
General Service Specifications SPECIFICATIONS
Radiator Cap Pressure 15 psi
Thermostat R & I
Vehicles without: Supercharger THERMOSTAT - VEHICLES WITHOUT: SUPERCHARGER
Vehicles with: Supercharger THERMOSTAT - VEHICLES WITH: SUPERCHARGER
Water Pump R & I
Vehicles without: Supercharger WATER PUMP - VEHICLES WITHOUT: SUPERCHARGER
Vehicles with: Supercharger WATER PUMP - VEHICLES WITH: SUPERCHARGER
Engine Mechanical
4.0L
Compression N/A
Oil Pressure N/A
Overhaul N/A
Torque TORQUE SPECIFICATIONS
Fluid Specifications See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate/Drive Plate Torque FLEXPLATE
Fuel System
Pressure Specification
Regulator disconnected 3.0 bar (44.1 psi)
Vacuum hose connected 2.6 bar (38 psi)
Fuel Pressure Test Procedure FUEL SYSTEM PRESSURE CHECK
Fuel Filter Location FUEL FILTER (IN-LINE)
Fuel Filter R & I FUEL FILTER
Ignition
Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
Coil-on-plug SPECIFICATION
Spark Plug
4.0L - Leaded markets - service fit only (Type example = NGKBKR5E-11)
Gap 1.0 - 1.1 mm (0.039 - 0.043 in.)
Torque 25-29 Nm
4.0L - Normally Aspirated (Type example = NGKPFR5G-11E)
Gap 1.0 - 1.1 mm (0.039 - 0.043 in.)
Torque 25 - 29 Nm
4.0L - Supercharged (Type example = NGKPFR6G-13E)
Gap 1.2 - 1.3 (0.047 - 0.051 in.)
Torque 25 - 29 Nm
Starting
Starter STARTING SYSTEM
Torque TORQUE SPECIFICATIONS
Wheel Alignment
Adjustment Specifications WHEEL ALIGNMENT SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Front Specifications
Rear Specifications
Wheel & Tire
Wheel Lug Nut Torque 88-102 Nm
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.