Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2002X-TYPE (X400) V6-2.5LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIR
2002 Jaguar X-Type (X400) V6-2.5L
Cruise Control Switch: Service and Repair
2002 Jaguar X-Type (X400) V6-2.5LSECTION Service and Repair
Speed Control Switch 19.75.25
Removal
1. Remove the driver air bag module.
2. Detach the speed control switch wiring harness.
3. Disconnect the speed control switch electrical connector.
4. Remove the speed control switch.
Installation
1. To install reverse the removal procedure.
- Tighten to 3 Nm.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.