System Specifications

2000 Jaguar XJR (X308) V8-4.0L SC (AJ27)SECTION System Specifications



Torques

Screws, front seat belt height adjuster to B/C post LH and RH 24 - 26 Nm
Nut, seat belt upper anchor to height adjuster LH and RH 30 - 40 Nm
Bolt, LH and RH rear seat belt lower anchor to BIW 30 - 40 Nm
Bolt, centre rear seat belt lower anchor to BIW 30 - 40 Nm
Bolts, rear seat belt automatic locking retractor LH, RH and centre to squab panel 30 - 40 Nm
Bolt, rear seat belt buckle LH, RH and centre to BIW 30 - 40 Nm
Bolt, front seat belt buckle LH and RH to seat rail 30 - 40 Nm
Bolt, front seat belt lower anchor LH and RH to seat rail 30 - 40 Nm
Bolts, front seat belt automatic locking retractor/pretensioner to B post 30 - 40 Nm
Bolts, side airbag to seat frame 9 - 11 Nm
Screws, front seat belt guide to B/C post 8 - 10 Nm
Screws, single point sensor to tunnel 5 - 7 Nm
Screws, side impact sensing module to 'B' post 5 - 7 Nm
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.