SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR2000XJR (X308) V8-4.0L SC (AJ27)REPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL LAMPTURN SIGNAL BULBSERVICE AND REPAIRFRONT DIRECTION INDICATOR
2000 Jaguar XJR (X308) V8-4.0L SC (AJ27)

Front Direction Indicator

2000 Jaguar XJR (X308) V8-4.0L SC (AJ27)SECTION Front Direction Indicator


Direction Indicator Side Repeater Lamp Bulb

Removal







1. Applying firm hand pressure to inner end, pivot indicator lamp assembly for access to outer end.







2. Exercising care to avoid damaging paintwork, use a small screwdriver at outer end of lamp, to press and release retaining clip.







3. Withdraw lamp from bumper for access and disconnect harness multiplug.







4. Rotate bulb holder 1/8 turn to release it from lamp assembly.







5. Withdraw bulb holder and remove bulb.

Installation
1. Install bulb in holder.
2. Install bulb and bulb holder in lamp assembly and rotate 1/4 turn to seat and retain.
3. Position direction indicator lamp at bumper aperture and connect harness multiplug.
4. Engage inner end tang of lamp in bumper aperture.
5. Pivot lamp assembly and firmly seat outer retaining clip in bumper aperture.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.