Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR1986VANDEN PLAS L6-4.2LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION CONTROL MODULESERVICE AND REPAIR
1986 Jaguar Vanden Plas L6-4.2L
Ignition Control Module: Service and Repair
1986 Jaguar Vanden Plas L6-4.2LSECTION Service and Repair
Ignition Components:
1. Be sure ignition switch is OFF.
2. Remove connector from amplifier.
3. Locate wire harness from amplifier to coil and disconnect wires at coil.
4. Remove two bolts securing amplifier to intake manifold.
5. Reverse steps to refit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.