Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJAGUAR1986VANDEN PLAS L6-4.2LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION CONTROL MODULEDESCRIPTION AND OPERATION
1986 Jaguar Vanden Plas L6-4.2L
Ignition Control Module: Description and Operation
1986 Jaguar Vanden Plas L6-4.2LSECTION Description and Operation
Amplifier AB 14
The amplifier consists of a solid state electronic module (GM) housed in an aluminium case with two pre-wired leads which connect to the low tension terminals of the ignition coil.
Connection from the distributor pick-up module is made by an assembly of two leads inside a screening braid which plugs into a socket on the amplifier side.
Amplifier:
Fig. 3 Ignition Amplifier:
The amplifier consists of a solid state electronic module (GM) housed in an aluminium case with two pre-wired leads which connect to the low tension terminals of the ignition coil.
Ignition Components:
Connection from the distributor pick-up module is made by an assembly of two leads inside a screening braid which plugs into a socket on the amplifier side.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.