Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (ENGINE CONTROL SYSTEM - 4.2L - DTC P0420 TO P1682)DTC P0641CIRCUIT DESCRIPTION
2006 Isuzu Ascender S, 5.3 M, 4WD
Circuit Description
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Circuit Description
WARNING: This page is about a different variant/trim than selected.
The Powertrain Control Module (PCM) provides a 5-volt reference to the following sensors:
- The Throttle Position (TP) sensor 1
- The Accelerator Pedal Position (APP) sensor 2
- The engine cooling fan speed sensor
- The AC pressure sensor
- The Fuel Tank Pressure (FTP) sensor
- The oil pressure sensor (OPS)
The PCM monitors voltage on the 5-volt reference circuit. If the voltage is higher or lower than required, DTC P0641 will set.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.