SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 4.2L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSAIR CLEANER OUTLET RESONATOR REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
  1. Connect the electrical connector to the IAT sensor.
    2. Fig 1: View Of Engine Bolts & Air Cleaner Outlet Resonator
    GM730135Courtesy of GENERAL MOTORS CORP.
  2. Install the air cleaner outlet resonator assembly (5) to the engine making sure of the following:
    • The crankcase ventilation hose (1) is connected to the valve cover port (2).
    • The air cleaner outlet resonator (5) is properly fit to the throttle body assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 2 air cleaner outlet resonator to engine bolts (4).

    Tighten:  Tighten the resonator to engine bolts to 6 N.m (53 lb in).

    4. Fig 2: Top Of Engine View
    GM732051Courtesy of GENERAL MOTORS CORP.
  4. Connect the air cleaner outlet duct to the air cleaner outlet resonator (3).
  5. Properly position the air cleaner outlet duct and air cleaner outlet resonator clamps (2).

    Tighten:  Tighten the clamps (2) to 4 N.m (35 lb in).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.