Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the radiator support diagonal brace if applicable. Refer to Brace Replacement - Radiator Support Diagonal in Body Front End.
- Disconnect the Secondary Air Injection (AIR) reaction pump inlet hose from the air cleaner air outlet duct.
- Loosen the 3 air cleaner housing retaining screws (1).
- Remove the air cleaner housing (2).
- Lift the air cleaner element (6) and air outlet duct (3) from the lower air cleaner housing/washer solvent tank assembly (4).
- Remove the air cleaner element (6) from the air outlet duct (3) with a twisting and pulling motion.
- Inspect the entire assembly for dust, debris, or water. Clean or replace as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.