Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 4.2L - INTRODUCTION (2 OF 2))COMPONENT LOCATORENGINE CONTROLS CONNECTORSTHROTTLE BODY CONNECTOR END VIEW
2006 Isuzu Ascender S, 5.3 M, 4WD
Throttle Body Connector End View
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Throttle Body Connector End View
WARNING: This page is about a different variant/trim than selected.
Throttle Body
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | D-GN | 485 | TP Sensor 1 Signal |
| B | L-BU/BK | 1688 | 5-Volt Reference |
| C | BK | 2752 | Low Reference |
| D | PU | 486 | TP Sensor 2 Signal |
| E | YE | 581 | TAC Motor Control - 1 |
| F | BN | 582 | TAC Motor Control - 2 |
| G | GY | 2701 | 5-Volt Reference |
| H | BK/WH | 1704 | Low Reference |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.