Secondary Air Injection (AIR) Solenoid(K18) Connector End View

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Secondary Air Injection (AIR) Solenoid(K18) Connector End View
WARNING: This page is about a different variant/trim than selected.
Secondary Air Injection (AIR) Solenoid(K18)

GM1526382Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 15460171
  • 6-Way F GT 150 Series Sealed (BK)
Pin Wire Color Circuit No. Function
1 D-BU/WH 6785 Air Injection Reaction Control Valve #1 Low Reference
2 YE 6787 Air Injection Reaction Control Valve #1 Control
3 BN/WH 6789 Air Injection Reaction Control Valve #1 Volt Reference
4 BK 350 Ground
5 PK/BK 415 Air Injection Reaction Solenoid Supply Voltage
6 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.