SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 649 (ANTILOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSFRONT WHEEL SPEED SENSOR REPLACEMENT
2006 Isuzu Ascender S, 5.3 M, 4WD

Front Wheel Speed Sensor Replacement

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Front Wheel Speed Sensor Replacement
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Wheel Speed Sensor
GM1787703Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Refer to Brake Dust Warning .

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Front Brake Rotor Replacement .
1 Wheel Speed Sensor Electrical Connector
Procedure: 
Release the electrical connector from the bracket.
2 Wheel Speed Sensor Bolt
CAUTION: Refer to Fastener Caution .

Tighten:  8 N.m (71 lb in)
3 Wheel Speed Sensor
Procedure: 
Route the wheel speed sensor electrical harness through the splash shield.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.