Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 636 (POWER STEERING SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Isuzu Ascender S, 5.3 M, 4WD
Fastener Tightening Specifications
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Electronic Power Steering Motor Control Module Bolt | 11.5 N.m | 102 lb in |
| Ground Terminal Nut | 9 N.m | 80 lb in |
| Lower Intermediate Shaft Pinch Bolt | 34 N.m | 25 lb ft |
| Power Steering Assist Motor Bolt | 18 N.m | 13 lb in |
| Power Steering Fluid Cooler Hose | 25 N.m | 18 lb ft |
| Power Steering Fluid Reservoir Stud | 9 N.m | 80 lb in |
| Power Steering Gear Hoses Bracket Bolt | 9 N.m | 80 lb in |
| Power Steering Gear Inlet Hose | 25 N.m | 18 lb ft |
| Power Steering Pump Bolt | 50 N.m | 37 lb ft |
| Rack and Pinion Outer Tie Rod End Nut | 25 N.m+90 degrees | 18 lb ft+90 degrees |
| Remote Power Steering Fluid Reservoir Bolt | 9 N.m | 80 lb in |
| Steering Gear Bolt | 110 N.m | 81 lb ft |
| Steering Gear Cylinder Pipe Fitting | 25 N.m | 18 lb ft |
| Transaxle Mount Bolt | 50 N.m | 37 lb ft |
| Transaxle Mount Bolt | 110 N.m | 81 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.