SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 636 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSELECTRONIC POWER STEERING MOTOR CONTROL MODULE REPLACEMENT
2006 Isuzu Ascender S, 5.3 M, 4WD

Electronic Power Steering Motor Control Module Replacement

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Electronic Power Steering Motor Control Module Replacement
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Electronic Power Steering Motor Control Module
GM1848011Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the knee bolster. Refer to Knee Bolster Replacement .
1 Electronic Power Steering Motor Control Module Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:  11.5 N.m (102 lb in)
2 Electronic Power Steering Motor Control Module

Procedure

  1. Disconnect any electrical connectors as needed.
  2. After repairs, perform the proper programming and calibration procedures. Refer to Power Steering Control Module Programming and Setup .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.