Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 621 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM & NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESVIDEO ENTERTAINMENT SYSTEM WIRELESS HEADPHONE MALFUNCTIONCIRCUIT/SYSTEM TESTING
2006 Isuzu Ascender S, 5.3 M, 4WD
Circuit/System Testing
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the infrared transmitter module.
- Test for less than 5 Ξ© between the ground circuit terminal 12 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, test for B+ between the accessory voltage circuit terminal 4 and ground.
- If less than the specified range, test the accessory voltage circuit for a short to ground or an open/high resistance.
- DVD playing, test for AC voltage between the following signal circuit terminals listed below and ground.
- Left DVD audio signal (+) - terminal 1
- DVD audio common (-) - terminal 2
- Right DVD audio signal (+) - terminal 3
- If AC voltage is not present, test the signal circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit tests normal, replace the radio.
- If all circuits test normal, replace the infrared transmitter module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.