SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 619 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSBATTERY NEGATIVE CABLE REPLACEMENT (LY7)INSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Battery Cable Retainers
    GM1916167Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable to the wiring loom and re-tape the loom.
  2. Install the battery cable retainers (1) to the engine.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the negative battery cable ground terminal to the transaxle.

    Tighten the negative battery cable ground terminal bolt to 45 N.m (33 lb ft).

    4. Fig 2: View Of Negative Battery Cable Ground Terminal Nut
    GM1822523Courtesy of GENERAL MOTORS CORP.
  4. Install the negative battery cable ground terminal to the wheelhouse stud.

    Tighten the ground terminal nut to 12 N.m (106 lb in).

    5. Fig 3: View Of Battery, Cables & Related Components
    GM1822518Courtesy of GENERAL MOTORS CORP.
  5. Connect the body wiring harness electrical connector (4) to the battery current sensor (5).
  6. Connect the negative battery cable electrical connector (7) to the body wiring harness electrical connector (2).
    7. Fig 4: View Of Battery Cables & Terminal Nut
    GM1822394Courtesy of GENERAL MOTORS CORP.
  7. Connect the positive and negative battery cable clip (3) to the battery tray support bracket.
  8. Install the battery box. Refer to Battery Box Replacement .
  9. Connect the negative battery cable and install the upper battery box. Refer to Battery Negative Cable Disconnection and Connection .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.