SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 595 (FRONT DRIVE AXLE)REPAIR INSTRUCTIONSDIFFERENTIAL CARRIER ASSEMBLY FINAL ASSEMBLY
2006 Isuzu Ascender S, 5.3 M, 4WD

Differential Carrier Assembly Final Assembly

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Differential Carrier Assembly Final Assembly
WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

  • J 45225  Axle Seal Installer. See Special Tools .
  • J 8092  Universal Driver Handle - 3/4 in - 10
  1. Inspect the alignment mark between the differential bearing adjuster and the differential carrier assembly case. If the line between the differential bearing adjuster and the differential carrier assembly case is not aligned, re-align the 2 components as necessary.
    2. Fig 1: Installing Left Side Inner Shaft Seal
    GM782727Courtesy of GENERAL MOTORS CORP.
  2. Install the left side inner shaft seal using the J 45225  (2) and the J 8092  (1). See Special Tools .
    3. Fig 2: Installing Right Side Inner Shaft Seal
    GM782610Courtesy of GENERAL MOTORS CORP.
  3. Install the right side inner shaft seal using the J 45225  (2) and the J 8092  (1). See Special Tools .
    4. CAUTION: Refer to Component Fastener Tightening Caution .
  4. Install the drain plug and tighten to 32 N.m (24 lb ft).
  5. Install the fill plug and tighten to 32 N.m (24 lb ft).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.